Audio Innovate AEM-100 Especificaciones

AEM-100i 2-Channel Pro DJ MixerAEM-100i 2-Channel Pro DJ MixerAEM-100i 2-Channel Pro DJ MixerAEM-100i 2-Channel Pro DJ MixerPlease kindly read this ma

10volume, and Hz controls frequency.4) Stutter: Cuts the source material in and out. The leftmost position is off. When turning the knobclockwise,

113) The effect section of the AEM-100i is like an instrument; the more you practice and push theboundaries, the better you will become at using it.

12maintained and cleaned. It also already comes with the cut in points pre-adjusted for minimum deadspace. Please see www.proxfade.co.uk for more in

13FRONT PANELMIC1, MIC2 connect 1/4” stereo jack microphones to either or both of these inputs.AUX1, AUX2 connect 1/8” stereo jack input sources such

14REAR PANEL20V~1A AC IN input from the transformer power supply included with the mixer. ***Please make surethe correct power supply is plugged in b

15BLOCK DIAGRAM:

16TECHNICAL SPECIFICATIONS:Inputs:Line/Aux: 10kΩ input impedance, 5.6mV rms sensitivity for 1.0V outputMic: 10kΩ input impedance, 1mV rms sensitivity

2TABLE OF CONTENTSWarranty Information p. 3Getting started p. 4-7Turntables rear panel p. 4CDs rear panel p. 4-5Front panel p. 5Before powering up the

3AEM-100i Audio Innovate Warranty and Servicing Policy Audio Innovate provides a warranty against manufacturing defects for either 1 year after the

4GETTING STARTED: Basic hookups and settings2 TURNTABLES REAR PANELREAR PANEL USING 2 TURNTABLES: AC power adapter connects to “20V~1A” Left turntab

5 “LINE1/PHONO1” switch set to “PHONO1” Right CD source goes to “LINE 2” using a dual RCA cord. “LINE3/PHONO2” switch set to “PHONO2” For powered

6Before powering up the unit:1) Make sure the PHONO / LINE switches at the top are set to match the hookups in the back.2) Set all EQ faders to the

7After powering up the unit:Do the following in order while music is playing for both CH1 and CH21) Adjust the GAIN knobs until the CH1 and CH2 meter

8The above is just a “quick start” guide for getting the mixer up andrunning for the first time, especially in an emergency. Please readthrough the r

9MIC1 and MIC2:The microphones connect via the front panel on the left side. Each microphone has bass, treble, and gainadjustments. The turn-on swit